======================
1.How to update s/w by PC?
======================
1) Prepare a twisted RS232C cable(pin-2 to pin-3,pin-3 to pin-2,pin-5 to pin-5).
2) Connect your PC and receiver with twisted RS-232C cable.
3) Turn on the receiver and press "POWER" key to make it standby, the LED dot will blink.
4) Run the update tool on your PC,Slect the <Download Main S/W>,press <Open> and select the bin file,then click <Start>,upgrade will begin.
5) After finishing, the LED will display "-End"

======================
2.How to update s/w by USB?
======================
1)copy the bin file in your U disk
2)Plug U disk to the STB.
3)press USB key to go to USB Menu
4)find the bin file in the list and press OK key 


=========================================
3.How to Enable Patch or Disable Patch?
=========================================
 F1-->000
=======================
4.How to Edit Patch key?
=======================
 After Enable the Patch, go to Main Menu---System setup--Key Menu

F1 edit TP.
======================
5.How to update the Patch key?
======================
1) Download the softcam.key from the internet.
2) Prepare a twisted RS232C cable(pin-2 to pin-3,pin-3 to pin-2,pin-5 to pin-5).
2) Connect your PC and receiver with twisted RS-232C cable.
3) Turn on the receiver and press "POWER" key to make it standby, the LED dot will blink.
4) Run the update tool on your PC,Slect the <Download Key>,press <Open> and select the softcam.key  file,then click <Start>,upgrade will gin.
5) After finishing, the LED will display "-End"


=================================
6.How to upload the Channel Data?
=================================
 a)Prepare a twisted RS232C cable(pin-2 to pin-3,pin-3 to pin-2,pin-5 to pin-5).
 b)Connect your PC and receiver with twisted RS-232C cable.For safety,you should switch off the    computer and the receiver before connection.
 c)Turn on the receiver and press "POWER" key to make it standby
 d)Run the upgrade tool on your PC, and config your correct COM.
 e)Slect the <Upload Data>,then click <Start>,upload will begin.
 f)During the uploading,the LED will display "Uxxx"(Upload the data to PC),at last it will display "-End".
 g)After uploading,it will generate a file(*.SDX) on the same directry of the update tool[Upgrade],the path name will display on the File Status. This file includes all the satellites, transponders ,channels and settings.




======================
7.How to use PIP funtion?
======================
1)Press PIP key and choose PIP to enter the list to select another in the same tp.
2)choose one chanel and press ok key .
3)press yellow buttom for help. [F1]ZOOM IN,[F2]ZOOM OUT Small Window,green key swap two channel





HotKeys:
1. F1+000: Patch Enable/Disable
2. F1+111: RS232 Mode List
--PC CSC ECM
--Twin Protocol
3. Infor+1: ALL ECM List
4. infor+0: Current Key Menu


 












